18/40
Home / FlyBC.ca Members Albums / Oz / Jon boat project /

Rear Scotty anchor puller sitting 100% horizontal.

ThumbnailsPreviousNext
Photo sizes slideshowShow file metadatadownload
RearAnchor.jpg Reverse side of the carpeted floor showing the gap for the chine. I cut and glued two pieces of corrugated plastic (3/8" coThumbnailsPrototype transducer mount to confirm positioning, then an aluminum model will be added with a bracket mount.Reverse side of the carpeted floor showing the gap for the chine. I cut and glued two pieces of corrugated plastic (3/8" coThumbnailsPrototype transducer mount to confirm positioning, then an aluminum model will be added with a bracket mount.Reverse side of the carpeted floor showing the gap for the chine. I cut and glued two pieces of corrugated plastic (3/8" coThumbnailsPrototype transducer mount to confirm positioning, then an aluminum model will be added with a bracket mount.Reverse side of the carpeted floor showing the gap for the chine. I cut and glued two pieces of corrugated plastic (3/8" coThumbnailsPrototype transducer mount to confirm positioning, then an aluminum model will be added with a bracket mount.
Visits
355

EXIF Metadata

Make
FUJIFILM
Model
FinePix A345
DateTimeOriginal
2005:07:26 06:50:06
ApertureFNumber
f/2.8